15.Attach each of the four Weight Guides (15) to the Weight Top Frame (66) with a 3/8” x 3 3/4” Bolt (59), a 3/8” Flat Washer (48), and a 3/8” Nylon Locknut (50).
Important: Go back and fully tighten all Nylon Locknuts used in steps 1 through 15.
Arm Assembly
16.Locate and open the parts bag labeled “ARM ASSEMBLY.”
Press a Plastic Bushing (100) onto each welded tube on the Press Frame (8).
Lubricate the 3/8” x 8” Bolt (52). Attach the Press Frame (8) to the welded tubes on the Press Base (6) with the Bolt and a 3/8” Nylon Locknut (50). Do not overtighten the Nylon Locknut; it must be easy to pivot the Press Frame.
17.Press a 1 3/4” Square Inner Cap (35) into the top of a Press Arm (77). Press a 1” Round Inner Cap (76) into the indicated hole in the Press Arm.
Attach the Press Arm (77) to the bracket on the Press Frame (8) with two 5/16” x 2 1/2” Bolts (87) and two 5/16” Nylon Locknuts (64).
Repeat this step to assemble the second Press Arm (77, not shown).
15 |
| 48 | 50 |
|
|
| 50 |
|
|
| 48 |
| 59 |
|
|
| 59 |
|
|
| 15 |
|
|
|
|
| 15 |
16 |
|
|
|
| 8 |
|
|
| 50 |
| 6 |
|
| Lubricate | |
|
|
| |
| 100 | Welded | 52 |
| Tube | ||
|
|
| |
17 |
|
|
|
35
76
8 | 64 |
|
87
77
10
