31.Remove a Pro Pulley (26) from the bag labeled “PULLEY BAG 2”.
Identify the Low Pulley Cable (75). It is approximately 143 1/2” long and it has a ball on one end and a loop on the other. Route the end with the loop through the slot in the cable guide on the Butterfly Base (4).
Route the Low Pulley Cable (75) under a Pro Pulley (26) as shown. Attach the Pro Pulley and a Cable Trap (25) to the bracket on the Butterfly Base (4) with a 3/8” x 2” Bolt (54) and a 3/8” Nylon Locknut (50).
Make sure the Cable Trap is oriented as shown.
32.Wrap the Low Pulley Cable (75) around a 3 1/2” Pulley (24) in the direction shown. Attach the Pulley and a Cable Trap (25) to the indicated hole in the Butterfly Upright (1) with a 3/8” x 4 3/4” Bolt (60) and a 3/8” Nylon Jamnut (63). Note: Thread the Jamnut only two turns onto the Bolt, since you will later attach another Pulley to the Bolt. Make sure the Cable Trap is oriented as shown.
33.Wrap the Low Pulley Cable (75) over a 3 1/2” Pulley
(24)in the direction shown. Attach the Pulley and a Cable Trap (25) to the lower hole in the Adjustable Pulley Plates (23) with a 3/8” x 2” Bolt (54) and a 3/8” Nylon Locknut (50). Make sure the Cable Trap is oriented as shown.
34.Remove the 3/8” Nylon Jamnut (63) from the 3/8” x 4 3/4” Bolt (60) inserted into the Butterfly Upright (1) in step 32.
Wrap the Low Pulley Cable (75) around a 3 1/2” Pulley (24) in the direction shown. Attach the Pulley and a Cable Trap (25) to the 3/8” x 4 3/4” Bolt (60) with the 3/8” Nylon Jamnut (63). Make sure the
Cable Trap is oriented as shown.
31 |
|
|
|
54 | 26 | 25 |
|
|
| ||
|
|
| |
Cable |
|
| 4 |
|
|
| |
Guide |
|
|
|
| 75 |
| 50 |
|
|
| |
32 | 60 |
|
|
|
|
| 1 |
|
| 24 |
|
|
| 25 |
|
|
|
| 63 |
|
| 75 |
|
33 |
|
|
|
|
|
| 23 |
|
|
| 50 |
| 54 |
|
|
|
|
| 25 |
|
| 75 | 24 |
|
|
| |
34 |
|
|
|
|
| 1 | 75 |
|
|
| |
|
| 25 |
|
| 60 |
| |
|
| 24 | 63 |
|
|
| |
15
