ASSEMBLY
To make assembly easier, carefully read the following assembly tips:
•Assembly requires two persons.
•Because of its weight and size, the weight bench should be assembled in the location where it will be used. Make sure that there is enough clear- ance to walk around the weight bench as you assemble it.
•Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.
•For help identifying small parts, use the PART IDENTIFICATION CHART on page 5.
•The included grease and the following tools (not included) may be required for assembly:
Two adjustable wrenches
One hammer
One standard screwdriver 
One Phillips screwdriver 
Assembly will be more convenient if you have a socket set, a set of
1.To make assembly easier, read the assem- bly tips at the top of this page before you assemble the weight bench.
Orient the Crossbar (3) so that the warning decals are on top.
Attach the Crossbar (3) to one of the Uprights (1) with two M8 x 55mm Bolts (18), two M8 Washers (16), and two M8 Locknuts (17); do not tighten the Locknuts yet.
Attach the Crossbar (3) to the other Upright
(1) in the same way.
1
1
3 |
| 1 | |
18 |
| ||
|
| ||
Warning | 18 | 16 | |
17 | |||
Decals |
2.Orient the Stabilizer (13) so that the indented holes are facing the floor.
Attach the Stabilizer (13) to the Front Leg (8) with two M8 x 42mm Carriage Bolts (37) and two M8 Locknuts (17); do not tighten the Locknuts yet.
2
8
17
17
Indents
13
6
37 
