7.Orient the Backrest Tubes (5) and the Backrest
(6) as shown.
Attach the Backrest Tubes (5) to the Backrest (6) with four M6 x 38mm Screws (30) and four M6 Washers (26); do not tighten the Screws yet.
8.Insert the Backrest Support (7) into a set of holes in the Uprights (1). Rotate the Backrest Support to the locked position, with the locking pin wrapped around the left Upright.
Apply grease to an M10 x 137mm Bolt (36). Attach the Backrest Tubes (5) to the welded tube on the Frame (2) with the M10 x 137mm Bolt (36), two M10 Washers (34), and an M10 Locknut (33). Do not overtighten the Locknut; the
Backrest Tubes must pivot easily.
See steps
9.Attach the Seat (11) to the Frame (2) with four M6 x 16mm Screws (29).
10.Slide a Weight Stop (28) onto the weight tube on a Fly Arm (25).
Slide a Weight Stop (not shown) onto the other Fly Arm (not shown) in the same way.
8
7 |
|
|
|
|
|
| 6 |
|
|
|
|
|
|
| 5 | 26 | |
|
|
| 30 |
| |
| Holes | 26 |
|
| |
|
|
| 30 |
|
|
8 | 1 |
|
|
|
|
|
|
|
|
| |
Grease |
|
| 1 |
| |
36 | 34 |
|
| 7 | |
5 |
|
|
| ||
34 |
| Locking | |||
2 | Welded | 3 | |||
|
|
| Pin | ||
| Tube |
|
|
|
|
9 | 11 |
|
|
|
|
|
|
|
|
| |
|
|
| 2 |
|
|
|
|
| 29 |
|
|
10 |
| 25 |
|
|
|
|
| Weight | 28 |
| |
|
| Tube |
| ||
