Weider Pro 2250 user manual

15. Wrap the Long Cable (23) over a “V”-pulley (6).	15
Attach the “V”-pulley and a Long Cable Trap (50)
to the Front Upright (42) with a 3/8” x 2 1/2” Bolt		6	7
(7) and a 3/8” Nylon Locknut (21).Make sure	42
that the Long Cable Trap is positioned to hold
the Cable in the groove of the “V”-pulley.			50
		23
		21
16. Route the Long Cable (23) around a “V”-pulley	16
(6). Attach the “V”-pulley and a Long Cable Trap
(50) to the Left Arm (47) with a 3/8” x 2 1/2” Bolt
(7) and a 3/8” Nylon Locknuts (21).Make sure		7	50
that the Long Cable Trap is positioned to hold		6
the Cable in the groove of the “V”-pulley.
Repeat this step with the Right Arm (48).			23
			47
		21
	48
	47
17. Note: The parts used in this step have been	17
preassembled. They are shown exploded in
		68
this drawing for clarity.
Route the Long Cable (23) over the 3 1/2” Pulley	20	66
	21
(15) attached to the Pulley Bracket (20). Make		15
sure that the Cable Trap (66) is oriented to
		12
hold the Cable in the groove of the Pulley.	3
			55
Tighten the 3/8” x 2” Bolt (12) and the 3/8” Nylon
Locknut (21).	23
Properly tighten the 5/16” x 5” Bolt (68) and a			Bracket
5/16” Nylon Locknut (3) attaching the Pulley
Bracket (20) to the bracket on the Top Frame
(55). Do not overtighten the Locknut; the
Pulley Bracket must be able to pivot easily.	18
18. Wrap the Long Cable (23) under a 3 1/2” Pulley
(15). Attach the Pulley and a Cable Trap (66) to		23
the indicated hole in the Long “U”-bracket (57)
with a 3/8” x 2” Bolt (12) and a 3/8” Nylon	15	66
Locknut (21). Make sure that the Cable Trap is
oriented to hold the Cable in the groove of the	12	21
Pulley.
		57
	10