11.Note: The 3 1/2” Pulley (15) in this step has been preassembled. It is shown exploded in this drawing for clarity.
Route the Short Cable (58) around the 3 1/2” Pulley (15). Make sure that the Cable Trap (66) is turned to hold the Cable in the groove of the Pulley. Tighten the 3/8” x 3 1/2” Bolt (16), the 3/8” Washer (9), and the 3/8” Nylon Locknut (21).
12.Route the Short Cable (58) under a 3 1/2” Pulley (15). Attach the Pulley and a Cable Trap (66) to the upper hole in the Front Upright (42) with a 3/8” x 3 3/4” Bolt (71), a 3/8” Washer (9), and a 3/8” Nylon Locknut (21).Make sure that the
Cable Trap is turned to hold the Cable in the groove of the Pulley.
13.Remove the preassembled 3 1/2” Pulley (not shown) from the Long
Attach the end of the Short Cable (58) to the Long
(2) and a 1/4” Washer (10).See the inset draw- ing. Do not overtighten the Locknut; it should be threaded onto the end of the Cable so that two threads are showing above the nut.
14.Note: The 3 1/2” Pulley (15) in this step has been preassembled. It is shown exploded in this drawing for clarity.
Locate the Long Cable (23). Route the Long Cable over a 3 1/2” Pulley (15).Make sure that the Cable is between the Pulley and the hook and that the end of the Cable with the ball is on the indicated side of the hook. Tighten the 3/8” x 3 3/4” Bolt (71) and the 3/8” Nylon Locknut (21).
11 |
|
|
|
|
| 21 |
|
|
|
| 66 |
|
|
|
| 15 | 58 |
|
|
| 17 | 9 |
| |
|
|
|
| |
|
|
| 16 |
|
12 |
|
|
|
|
|
|
| 42 |
|
|
| 21 | 9 |
|
|
|
| 58 |
|
|
|
| 15 66 | 71 |
|
|
|
| |
13 |
|
|
|
|
2 | 57 |
|
|
|
10 |
|
|
|
|
|
|
|
| 2 |
58 |
|
|
|
|
|
|
|
| 10 |
|
|
| 57 | 58 |
|
|
|
| |
14 |
|
|
|
|
| 21 | 55 |
|
|
Hook |
|
|
| |
|
| 15 | 71 |
|
| 23 |
|
| |
| Ball |
|
| |
|
|
|
| |
9
