8.Identify the Right Arm (48) and the Left Arm (47) by the position of the welded bracket on each Arm.
Press a 2” Round Inner Cap (33) into the lower end of the Left Arm (47). Wet the end of the Arm with soapy water and slide a 10” Pad (45) onto it. Make sure the 1 1/8” x 2 1/2” Plastic Bushing (74) is in the Arm.
Lubricate both axles on the Top Frame (55). Have another person slide the Left Arm (47) onto the left axle on the Top Frame. Note: Be careful not to confuse the Right Arm (48) with the Left Arm. Make sure that the upper end of the Left Arm is behind the indicated bracket on the Top Frame.
Set two 1” Retainers (69) on top of a 1” Round Cover Cap (70). Make sure that the teeth on the
Retainers bend toward the Cover Cap, as shown in the inset drawing. Tap the Retainers and Cap onto the Left axle on the Top Frame (55).
Attach the Right Arm (48) in the same manner.
Cable Assembly
9.During steps 9 through 20, see the CABLE DIAGRAMS on page 17 of this manual to verify proper cable routing.
Locate the Short Cable (58). Lay the Cable in the bracket on the Base (4) and under the Press Frame (17). Attach a 3 1/2” Pulley (15) to the bracket with a 3/8” x 2” Bolt (12) and a 3/8” Nylon Locknut (21). Make sure that the end of the
Cable with the ball is on the indicated side of the bracket.
10.Route the Short Cable (58) under a 3 1/2” Pulley (15) Attach the Pulley and a Cable Trap (66) to
the lower hole in the Front Upright (42) with a 3/8” x 3 3/4” Bolt (71), a 3/8” Washer (9), and a 3/8” Nylon Locknut (21). Make sure that the Cable
Trap is turned to hold the Cable in the groove of the Pulley.
8
8 |
|
|
|
55 |
|
|
|
48 |
|
|
|
Bracket |
|
| |
Lubricate | 74 |
| |
Axle |
| ||
|
| ||
| 69 |
|
|
| 70 | 47 | |
|
| ||
55 |
|
|
|
69 | 33 |
| |
| 45 | ||
|
|
| |
70 |
|
|
|
9 |
|
|
|
17 |
|
|
|
15 |
|
|
|
21 |
|
|
|
58 |
|
|
|
| 12 |
|
|
| 4 |
|
|
Bracket |
|
| |
10 |
|
|
|
| 42 |
|
|
21 | 9 |
|
|
| 15 | 66 | 71 |
|
|
| |
| 58 |
|
|
