11. Place the treadmill in the storage position (see HOW TO | 11 |
|
FOLD THE TREADMILL FOR STORAGE on page 23). |
| |
Center the Frame (48) between the Uprights (73, 74). |
| 48 |
Tighten the Upright Bolts (72) in the lower ends of the |
| |
Uprights (73, 74). |
| 74 |
| 73 | |
|
|
72
72
12.Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included allen wrench in a secure place; the allen wrench is used to adjust the walking belt (see page 26). To protect the floor or carpet, place a mat under the treadmill.
If you purchase the optional chest pulse sensor (see page 22), follow the steps below to install the re- ceiver included with the chest pulse sensor.
1. | Make sure that the power cord is unplugged. Remove |
|
|
|
| the indicated Console Back Screw (67) and the Access |
|
| 69 |
| Door (70) from the left side of the Console Back (69). |
|
| |
2. | Connect the wire on the receiver (A) to the indicated wire |
| Small |
|
| extending from the Console Back (69). Hold the re- |
| Screws | Small |
| ceiver so the small cylinder is oriented as shown. |
|
| |
| Attach the receiver to the plastic posts on the Access |
|
| Cylinder |
3. | Door (70) with the two included small screws. | Wire | A |
|
Make sure that no wires are pinched. Reattach the |
| |||
| Access Door (70) with the Console Back Screw (67). The |
|
|
|
| other wires included with the receiver may be discarded. |
| 70 | 67 |
|
|
|
10
