Weider WEBE19710 user manual

15. Route the Long Cable (34) up through the Weight	15
Frame (10), over a 3 1/2” Pulley (27), and back			24
		31			27
down through the Weight Frame. Attach the
					32
Pulley to the Weight Frame with an M10 x 75mm
			32
Bolt (31), two Short Spacers (32), two M10					24
Washers (24), and an M10 Nylon Locknut (26).			34
					26
			10
16. Attach the metal-sleeve end of the Long Cable	16
(34) to the M10 x 19mm Bolt (40) on the Weight
Carriage (13) with an M10 Nylon Locknut (26).			13		40
Do not overtighten the Nylon Locknut; the
Cable must be able to pivot freely.
			26 34
17. Locate the Short Cable (33); note that there are	17
two balls on one end of the Short Cable and a
metal sleeve on the other end.			27
Lay the ball-end of the Short Cable (33) inside the		29
bracket on the Center Base (7). Attach a 3 1/2”
Pulley (27) inside the bracket using an M10 x	33
45mm Bolt (29) and an M10 Nylon Locknut (26).
					26
				7
18. Wrap the Short Cable (33) around a 3 1/2” Pulley	18
(27) as shown. Attach the Pulley and a Cable
Trap (39) to the Pulley Plates (28) with an M10 x
45mm Bolt (29) and an M10 Nylon Locknut (26).
	29
		28		26
		27
		33		39
19. Attach the Short Cable (33) to the Weight Base	19
(20) with an M10 x 75mm Bolt (31), two M10
Washers (24), two Long Spacers (41), and an	31	33
M10 Nylon Locknut (26).
	24				20
	41				41
					24
					26
	9