3.Press two Bushings (34) into the Bench Frame
(2).
Attach the Bench Frame (2) to the Front Leg (4) with four M10 x 94mm Bolts (18), two Joint Plates (39), and four M10 Nylon Locknuts (32). Do not tighten the Locknuts yet.
4.Press four 20mm x 40mm Inner Caps (20) into the ends of the two Backrest Frames (6).
Attach the Backrest Frames (6) to the Backrest Bracket (9) with four M10 x 58mm Bolts (73), four M10 Washers (74), and four M10 Nylon Locknuts (32). Make sure the Backrest Frames are ori- ented as shown. The Backrests Frames must be parallel, with the indicated holes aligned.
5.Attach the Backrest (10) to the Backrest Frames
(6) with four M6 x 53mm Bolts (29) and four M6 Washers (37). Note: If the four Bolts will not insert into the Backrest properly, go back to step 4 and readjust the Backrest Frames.
3 |
|
|
|
39 | 34 | 2 |
|
|
| ||
32 |
|
|
|
|
|
| 34 |
4 |
|
|
|
|
| 39 | 18 |
|
|
| |
4 |
|
| 73 |
| 73 |
| |
|
| 20 | |
|
|
| |
| 74 |
|
|
| 74 |
|
|
6 |
|
|
|
Holes |
|
|
|
20 |
|
|
|
9 |
|
|
|
|
| 32 |
|
5 |
|
|
|
10 |
|
| |
|
|
| 6 |
|
|
| 37 |
37 |
|
| 29 |
|
|
| |
29 |
|
|
|
6
