13.Attach a Rear Upright (43) to the Left Base (40) with two M10 x 78mm Bolts (32) and two M10 Nylon Locknuts (34). Note: The Rear Uprights are shorter than the Front Uprights (not shown). Make sure the holes are on the side shown. Do not tighten the Locknuts yet.
Repeat this step with the other Rear Upright (43) and the Right Base (38).
14.Press a 60mm Square Inner Cap (64) into the top of the Left Front Upright (44).
Attach the Left Front Upright (44) to the Left Base
(40)with four M10 x 78mm Bolts (32), two Rack Joint Plates (85), and two M10 Nylon Locknuts
(34).Do not tighten the Locknuts yet.
Make sure the holes on the Left Front Upright
(44)face the holes on the Rear Upright (43), and that the numbers on the Left Front Upright face the numbers on the Right Front Upright (not shown).
Repeat this step with the right Front Upright (not shown) and the Right Base (38).
13 |
|
| 43 |
| 43 |
| Holes |
| 34 |
38 | 32 |
| 40 |
14 |
|
| 64 |
| 43 |
38 |
|
| 44 |
| Holes |
| Numbers |
32 | 32 |
| |
| 85 |
| 40 |
| 85 |
| 34 |
| 34 |
10
