44.Wrap the Low Cable (58) over a Small Pulley
(59).Attach the Small Pulley, two Half Guards (62), and a Cable Trap (76) to the second from the bottom set of holes in the two Pulley Plates
(56)with an M10 x 50mm Bolt (111) and an M10 Nylon Locknut (94). Make sure the Half Guards are oriented as shown.
45.Wrap the Low Cable (58) under a Small Pulley
(59).Attach the Small Pulley and a Cable Trap
(76)to the second hole in the Rear Base (25) with an M10 x 50mm Bolt (111) and an M10 Nylon Locknut (94).
46.Attach the Low Cable (58) to the “U” Bracket (57) with an M8 Nylon Locknut (97) and an M8 Washer (95). See the inset drawing. Do not completely tighten the Nylon Locknut; it should be tightened so that only two threads of the Cable show past the Nylon Locknut.
44 |
| |
94 | 62 | |
62 | 111 | |
56 |
| |
59 | 76 | |
58 |
| |
45 |
| |
58 | 59 | |
94 | ||
76 | ||
| ||
| 111 | |
| 25 | |
46 |
| |
57 | 97 | |
95 | ||
| ||
| 58 | |
| 57 | |
| 97 | |
| 58 |
22
