Weider WESY17011 user manual ARM Assembly, Tighten the Nylon Locknuts used in steps

3.Press a 45mm Square Inner Cap (44) into each end of the crossbar on the Top Frame (55). Press two 25mm Round Inner Caps (49) into the top of the crossbar. Press a 50mm Square Inner Cap

(27)into the top of the Rear Upright (56).

Attach the Top Frame (55) to the Front Upright

(42)with a Support Plate (68), two M8 x 67mm Bolts (61), and two M8 Nylon Locknuts (3). Attach the Top Frame to the Rear Upright (56) with the other Support Plate, two M8 x 67mm Bolts (61), and two M8 Nylon Locknuts (3).

Tighten the Nylon Locknuts used in steps 1–3.

ARM ASSEMBLY

4.Press a 25mm Plastic Bushing (26) onto each welded spacer on the Press Frame (17). Orient the Press Frame so the indicated hole is on the side shown. Slide the Press Frame onto the Base

(4) so the Plastic Bushings are aligned with the indicated tube. Note: This will be a tight fit. The

Plastic Bushings should fit onto the ends of the welded tube in the Base.

Lubricate an M10 x 198mm Bolt (59). Attach the Press Frame (17) to the Base (4) with the Bolt, two M10 Washers (9), and an M10 Nylon Locknut (21).

5.Press a 45mm Square Inner Cap (44) into the top of one of the Press Arms (46). Press a 25mm Round Inner Cap (49) into each end of the handle on the Press Arm. Attach the Press Arm to one side of the Press Frame (17) with two M8 x 63mm Bolts (22) and two M8 Nylon Locknuts (3).

Assemble the other Press Arm (46) in the same manner.

6.Identify the Left Arm (47) and the Right Arm (48). Note the position of the welded bracket on each Arm. Arm identification is very important for step 7.

Press a Butterfly Arm Bushing (60) into each Arm (47, 48).

3		61
55		68	49
			44
27
68		3
			Crossbar
61		44
56	3	42
4
		17	Hole
			Lubricate
		21	59
4			9
			Welded
Tube		9	Spacers
		26
5			44
			49
44
49	49		46
46	22
		3
		17
6		60
60			47
		Welded
48		Brackets

7