Weider WESY17011 user manual Inset shows view

21. Route the Short Cable (23) up around the	21	42
90mm Pulley (15) attached to the upper hole in
		15
the Press Frame (17). Be sure that the Cable is
routed around the Pulley as shown, and that
the Cable Trap (66) is turned to hold the Cable
in place.		66
Route the Short Cable (23) around the		23
90mm Pulley (15) attached to the upper hole in		42
the Front Upright (42). Refer to the inset draw-		Inset shows view
ing. Be sure that the Cable is routed around		from other side
the Pulley as shown, and that the Cable Trap
(66) is turned to hold the Cable in place.		23
		15
		15
		66
		21
		17
22. Attach the end of the Short Cable (23) to the	22
Long “U”-Bracket (57) with an M8 Nylon Locknut
(3) and an M8 Washer (8). Do not completely
tighten the Nylon Locknut; it should be
threaded onto the end of the Cable until two
threads are showing above the Nylon
Locknut, as shown in the inset drawing.
	3
		57
	8
		23
		3
	57	23

12