Weider WESY2966.0 user manual

11.	Route the Long Cable (42) under a 90mm	11
	Pulley (38). Attach the Pulley, a Cable Trap
				42	37
	(39), and two Half Guards (37) to the indicated
	hole in the Base (2) (see the inset drawing) with			38
	an M10 x 52mm patch Screw (76) and an M10		37			89
	Washer (59). Make sure that the Cable Trap				59
	is oriented to hold the Cable in the groove			39
	of the Pulley.
		Hole	2
					2
12.	Attach a Pulley Bracket (17) to the indicated	12
	“U”-channel (18) with an M10 x 132mm Button
	Bolt (72), two M10 Washers (59), and an M10				18
	Nylon Locknut (56).
	Wrap the Long Cable (42) over a 90mm Pulley		72	59	17	59
	(38). Attach the Pulley inside the Pulley Bracket
	(17) with an M10 x 42mm Button Bolt (71) and
	an M10 Nylon Locknut (56).					56
				71		56
				38		42
13.	Wrap the Long Cable (42) under a 90mm	13
	Pulley (38). Attach the Pulley, a Cable Trap
	(39), and two Half Guards (37) to the Base (2)
	with an M10 x 52mm Patch Screw (89) and an			42
	M10 Washer (59). Make sure that the Cable					89
	Trap is oriented to hold the Cable in the
	groove of the Pulley.			37		37
	Note: The Half Guards (37) attached in this					59
	step will overlap the Half Guards attached in				38
	steps 8 and 11.				39
						2
		10