58.Remove the M10 Nylon Locknut (75) used in step 50.
Attach the Low Cable (63) to the M10 x 110mm Bolt (90) in the Right Upright (5) with two M10 Washer (74), and the M10 Nylon Locknut (75).
Seat Assembly
59.Locate and open the parts bag labeled “SEAT ASSEMBLY.”
Attach the Seat (26) with the serial number decal to the Left Seat Frame (4) with four M6 x 16mm Screws (79).
Attach the other Seat (26) to the Right Seat Frame (not shown) in the same manner.
60.Press a 38mm Square Inner Cap (44) into a Backrest Frame (16). Attach a Backrest (27) to the Backrest Frame with four M6 x 20mm Screws (64).
Pull the Backrest Knob (48) on the Left Upright
(6)out as far as it will go and insert the Backrest Frame (16) into the Upright. Engage the Knob into one of the holes in the Backrest Frame, and turn the Knob clockwise until it is tight.
Attach the other Backrest to the Right Upright (not shown) in the same manner. Note: The tops of the Backrests should be closer to the Uprights than the bottoms.
61.Press the two 19mm Round Inner Caps (24) into the ends of a Pad Tube (17). Insert the Pad Tube into the tube on the Left Leg (8). Slide the two Foam Pads (25) onto the Pad Tube as shown.
Assemble the other Pad Tube (17) to the Leg Lever (18) in the same manner.
58 |
|
|
|
| 5 |
| 74 |
| 90 |
|
|
|
| 63 | 75 |
|
|
| |
59 |
|
|
|
|
|
| 26 |
| 4 |
| Wide |
|
| End | |
|
| 79 |
|
Serial Number Decal |
|
| |
60 |
|
|
|
6 44 | 64 |
|
|
| 64 |
| 27 |
|
|
| |
48 |
|
|
|
|
| 16 |
|
61 |
|
|
|
|
|
| 17 |
|
|
| 18 |
|
| 8 |
|
|
|
| 25 |
|
|
| 24 |
25 |
| 17 |
|
|
|
| |
| 24 |
|
|
21
