Weider WESY37530 Easily, Outer Cap 47. Make sure the teeth on, Rings are toward the Cap, as shown

18. Press a 50mm Square Inner Cap (43) into a	18
Press Arm (15). Press two 25mm Round Inner
Caps (65) into the Press Arm.
Wet the handles on the Press Arm (15) with
soapy water. Slide two Grips (68) onto the han-
dles.		68	43
	15
Attach the Press Arm (15) to the Press Frame
(14) with two M10 x 70mm Bolts (87) and two
M10 Nylon Locknuts (75).			65
Attach the other Press Arm (15) to the Press		15
Frame (14) in the same manner.
		75
	87	14
19. Press two 50mm Square Inner Caps (43) into the	19
Leg Lever (18).
	8	43
Lubricate an M10 x 78mm Bolt (86) with grease.		75
Orient the Leg Lever (18) as shown and attach it
to the Left Leg (8) with the Bolt and an M10	86	18
Nylon Locknut (75). Do not overtighten the
Locknut; the Leg Lever must be able to pivot	Lubricate		Small
easily.			Slot
		43
20. Lubricate both axles on the Left Top Frame (11)	20
with grease.
			11
Press a 38mm Square Inner Cap (44) into the			Axle
Left Fly Pivot (21). Slide the Left Fly Pivot onto
the indicated axle on the Left Top Frame (11). Set
two 25mm Retainer Rings (53) on a 25mm Round	Axle	22	21
Outer Cap (47). Make sure the teeth on the
Rings are toward the Cap, as shown in the	53	44	53
inset drawing. Tap the Retainer Rings and Outer
Cap onto the axle. Repeat with the Right Fly	47		47
Pivot (22).
21. Press a 50mm Square Inner Cap (43) into a	21
Butterfly Arm (20).
Wet a Fly Handle (66) and the inside of a Long		20
Foam Pad (33) with soapy water. Slide the Foam		33	66
Pad onto the Handle.
Attach a Fly Handle (66) to the Butterfly Arm (20)
with two M10 x 25mm Button Screws (60) and
two M10 Washers (74).
Repeat this step with the other Butterfly Arm	60	74
(not shown). Make sure that the Fly Handle is		43
oriented as shown in step 22.
	12