35.Locate the Leg Press Cable (78). Attach the end of the Leg Press Cable to the Long
Locknut. It should be threaded onto the end of the Cable only a couple of turns, as shown in the inset drawing.
Wrap the Leg Press Cable (78) around a 3 1/2” Pulley (15). Attach the Pulley to the Leg Press Upright (56) with the 3/8” x 3 3/4” Bolt (88), a 3/8” Washer (9), and a 3/8” Nylon Locknut (21).Be sure that the Cable and Pulley move smoothly and that the Cable is between the Pulley and the welded rod. The ball on the Cable must be on the indicated side of the Pulley.
36.Attach the Press Bracket (94) to the Leg Press Arm (96) with a 3/8” x 3” Bolt (100) and a 3/8” Nylon Jamnut (99).
Wrap the Leg Press Cable (78) around a 3 1/2” Pulley (15). Attach the Pulley to the Press Bracket
(94)with a 3/8” x 2” Bolt (12) and a 3/8” Nylon Locknut (21).
Slide a 5/16” Washer (8) onto a 5/16” x 2 3/4” Bolt (11). Insert the Bolt through the center hole in the Leg Press Seat Frame (79) from the indicated side. (Note: The three holes are for cable adjustment.) Tighten a 5/16” Washer (8) and a 5/16” Nylon Jamnut (93) onto the Bolt. Slide the end of the Leg Press Cable (78) onto the end of the Bolt. Thread another 5/16” Nylon Jamnut onto the Bolt.Do not fully tighten the second Jamnut; there must be room between the two Jamnuts for the end of the Cable to pivot.
17
35 |
|
|
|
|
|
2 |
|
|
|
|
|
|
|
| 56 |
| |
10 | 57 |
|
| Ball | |
| 15 |
|
| ||
|
|
|
|
| |
88 |
|
|
| 9 | |
|
|
|
| ||
| 78 |
|
|
| 21 |
| Welded |
|
|
|
|
| Rod |
|
|
|
|
| 2 |
|
|
|
|
| 10 |
|
|
|
|
78 | 57 |
|
|
|
|
|
|
|
|
| |
36 |
|
|
|
|
|
|
|
|
|
| 96 |
| 11 |
| 99 |
| 12 |
|
| 94 |
|
| |
| 8 | 78 |
| 100 | |
|
|
|
| ||
|
|
| 15 |
| 21 |
|
|
| 8 | ||
|
|
|
| ||
| 79 |
|
|
|
|
|
|
|
|
| 93 |
