Weider WESY39311 user manual

22.See the inset drawing. Attach a 3 1/2” Pulley (15) and a Cable Trap (66) to the upper hole in a Long “U”-Bracket (57) with a 3/8” x 2” Bolt (12) and a 3/8” Nylon Locknut (21). Be sure that the Cable Trap is inside the Long “U”-Bracket. Note: This may come pre-assembled.

Route the High Cable (58) through the Long “U”- Bracket (57) and the 3 1/2” Pulley (15) shown in the inset drawing. Be sure that the Cable is in the groove of the Pulley and that the Cable and Pulley move smoothly.

23.Wrap the High Cable (58) around a 3 1/2” Pulley (15). Attach the Pulley to the bracket on the Top Frame (55) with a 3/8” x 2” Bolt (12) and a 3/8” Nylon Locknut (21). Be sure that the Cable is in the groove of the Pulley and that the Cable and Pulley move smoothly.

24.Attach the High Cable (58) to a Small “U”-Bracket

(71)with a 1/4” Nylon Locknut (2) and a 1/4” Washer

(10).Do not completely tighten the Nylon Locknut. It should be threaded onto the end of the Cable only a couple of turns, as shown in the inset drawing.

Attach the Small “U”-Bracket (71) to the indicated Weight Tube (63) with a 5/16” x 1 3/4” Bolt (24) and a 5/16” Nylon Locknut (3).

13

22
	58
66	15
21		15
57	12	58
	57
23
		12
	Bracket	58
		15
		55
21
24
	58
	3
		24
	71
	63
	58	10
71
	10	2
	2