32.Wrap the Military Press Cable (72) around a 3 1/2” Pulley (15). Attach the Pulley and a Cable Trap (66) to the Pivot Arm (80) with the 3/8” x 5” Bolt (101).
Be sure the Bolt is on the side shown, and that the Cable Trap is positioned to hold the Cable in place. Do not attach a locknut yet.
See the inset drawing. Wrap the Military Press Cable (72) around a 3 1/2” Pulley (15). Attach the Pulley and a Cable Trap (66) to the upper hole in the Long
Cable Trap is inside the Long
Wrap the Military Press Cable (72) around another 3 1/2” Pulley (15). Attach the Pulley and a Cable Trap (66) to the 3/8” x 5” Bolt (101) on the other side of the Pivot Arm (80) with a 3/8” Nylon Locknut
(21).Be sure that the Cable Trap is positioned to hold the Cable in place, and that the Cable is routed as shown.
33.Wrap the Military Press Cable (72) around a 3 1/2” Pulley (15). Attach the Pulley and a Cable Trap (66) to the Leg Press Upright (56) with a 3/8” x 2” Bolt
(12)and a 3/8” Nylon Locknut (21).Be sure the
Cable Trap is positioned to hold the Cable in place.
34.Lay the Military Press Cable (72) over a 3 1/2” Pulley (15). Attach the Pulley and both Pulley Covers (77) to the Leg Press Upright (56) with a 3/8” x 3 3/4” Bolt (88), two 3/8” Washers (9), and a 3/8” Nylon Jamnut (99).
Make sure that the Military Press Cable (72) is between the 3 1/2” Pulley (15) and the post. Be sure that the Cable and Pulley move smoothly.
The Pulley Covers (77) must be turned so that the large tabs face toward the weight system. See the inset drawing.
16
32 |
|
|
|
101 | 15 |
|
|
66 |
|
| |
|
| 80 |
|
| 72 |
|
|
|
| 66 |
|
|
| 21 |
|
| 57 |
| 15 |
|
|
| |
|
| 21 | 66 |
|
| 57 | 12 |
33 |
|
|
|
|
| 56 |
|
| 21 |
|
|
|
| 66 | 72 |
|
|
| |
|
|
| 15 |
|
|
| 12 |
34 | 99 |
|
|
| 72 |
| |
| 9 |
| |
|
|
| |
| Post |
|
|
|
| 15 |
|
| 77 |
| Large tabs |
| 9 | must be in | |
|
| ||
|
| this location | |
|
| 88 | |
|
|
| |
| 56 |
|
|
