22.Locate the Short Cable (58). Route the Short Cable under the 3 1/2Ó Low Pulley (77).
Be sure that the end of the Cable with the ball is on the indicated side of the Pulley and that the Cable is between the Pulley and the welded spacer on the Leg Lever (29). Tighten the 3/8Ó x 3 1/2Ó Bolt (16) and the 3/8Ó Nylon Locknut (not shown).
23. Wrap the Short Cable (58) around a ÒVÓ-
| Pulley (6). Attach the Pulley and a Long |
| Cable Trap (50) inside the bracket on the |
| Seat Frame (36) with a 3/8Ó x 2 1/2Ó Bolt (7) |
| and a 3/8Ó Nylon Locknut (21). Be sure that |
| the Cable Trap is turned to hold the Cable |
| in place and that the Cable is routed |
| around the Pulley as shown. |
ASSEMBLY | 24. Wrap the Short Cable (58) around a 3 1/2Ó |
| |
CABLE | Pulley (15). Attach the Pulley to the Rocker |
turned to hold the Cable in place and that | |
| Arm (32) with a 3/8Ó x 3 1/2Ó Bolt (16), a 3/8Ó |
Flat Washer (9), and a 3/8Ó Nylon Locknut (21). Be sure that the Cable Trap (66) is
the Cable is routed around the Pulley as shown.
25.Note: The 3 1/2Ó Pulley (15) labeled in this step is
Route the Short Cable (58) around the 3 1/2Ó Pulley (15) attached to the lower hole in the Front Upright (42). Be sure that the Cable
Trap (66) is turned to hold the Cable in place and that the Cable is routed around the Pulley as shown. Tighten the 3/8Ó Nylon Locknut (21) and the 3/8Ó x 3 3/4Ó Bolt (71).
12
22 |
|
|
|
| 29 |
|
|
| 16 |
|
|
58 | 77 | Ball | |
| |||
|
| Welded Spacer | |
23 |
|
|
|
6 | 58 |
|
|
| 21 |
|
|
50 | 7 |
|
|
|
|
| |
| 36 |
|
|
24 |
| 66 |
|
| 15 |
| |
|
|
| 16 |
32 |
|
| 58 |
|
|
| |
21 |
|
|
|
9 |
|
|
|
25 |
|
|
|
42 |
|
| |
| 71 |
|
|
15 | 66 |
|
|
21 | 58 |
|
|
9 |
|
|
|
