Weider WESY85290 manual Cable Assembly

CABLE ASSEMBLY

26.Note: The 3 1/2Ó Pulley (15) labeled in this step is pre-attached. It is shown removed for easy part identification.

Route the Short Cable (58) around the 3 1/2Ó Pulley (15) attached to the upper hole in the Press Frame (17). Be sure that the Cable is routed around the Pulley as shown.

Tighten the 3/8Ó Nylon Locknut (21) and the 3/8Ó x 3 1/2Ó Bolt (16).

27.Note: The 3 1/2Ó Pulley (15) labeled in this step is pre-attached. It is shown removed for easy part identification.

Route the Short Cable (58) around the 3 1/2Ó Pulley (15) attached to the upper hole in the Front Upright (42). Be sure that the Cable

Trap (66) is turned to hold the Cable in place and that the Cable is routed around the Pulley as shown. Tighten the 3/8Ó Nylon Locknut (21) and the 3/8Ó x 3 3/4Ó Bolt (71).

28.Attach the end of the Short Cable (58) to the Long ÒUÓ-Bracket (57) with a 1/4Ó Nylon Lock- nut (2) and a 1/4Ó Flat Washer (10). Do not completely tighten the Nylon Locknut. It should be threaded onto the end of the Cable so only a couple of threads are showing above the nut, as shown in the inset drawing.

13

26
			16
			9
			17
			58
			15
21	66
27	42		58
		15	21
	9		66
	71
28
	2
			57
	10
			58
	2
	10
57	58