Grease Trough And Grease Cup Installation | Wells WV-4HSRWT, WV-4HF

SLIP / FALL HAZARD SPILLED OIL

INSTALLATION (continued)

WARNING

SLIP / FALL HAZARD SPILLED OIL

GREASE TROUGH AND GREASE CUP INSTALLATION

1.Install the GREASE TROUGH into the brackets below the grease baffle.

2.Install the GREASE CUP on the right side of the unit, directly below the grease trough.

DO NOT OPERATE UNLESS

THE GREASE CUP IS

INSTALLED.

Oil and moisture will drip onto the floor and falls may result. Death or serious injury may result from slipping and falling

CAUTION:

BURN HAZARD

DO NOT OPERATE UNLESS

GREASE TROUGH

IS INSTALLED. Moisture will drip into the hot cooking surface, causing splattering of hot liquids. Serious injury can result from contact with hot splatter.

ROLL WARMER INSTALLATION

1.Be sure roller catches (inside warmer cavity) are in the open position. Install drawer assemblies in drawer slides.

2.Place appropriate one drawer insert pan into each warmer drawer. If used, place one Humitrol rack into each drawer pan.

HUMITROL

RACK

DRAWER

INSERT PAN

AIR VENT

CONTROL

	DRAWER	ROLLER
	STOP	ROLLER
	STOP	CATCH
		CATCH
	DRAWER
	ROLLER
	DRAWER
	SLIDE

DRAWER

CATCH DRAWER ASSEMBLY

(shown from back)

Fig. 8 Roll Warmer Drawer Pan Installation

504 p/n 303903 opM WV-4H Ventless Hotplate Cooktop

12

Image 14

Wells WV-4HSRWT Grease Trough And Grease Cup Installation, Roll Warmer Installation, Slip / Fall Hazard Spilled Oil

Contents

THIS MANUAL MUST BE READ AND UNDERSTOOD BY ALL PERSONS USING OR IMPORTANT DO NOT DISCARD THIS MANUALWV-4HSRWT Includes INSTALLATION USE & CARE WV-4H SERIES 504 p/n 303903 opM WV-4H Ventless Hotplate Cooktop INTRODUCTION see pages 4 Fig. 1 Ventilator Section Operating Features & ControlsVENTILATOR CONTROL PANEL COOKTOP CONTROL PANEL 504 p/n 303903 opM WV-4H Ventless Hotplate Cooktop Fig. 4 Cooktop & Warmer Drawer Operating Features & Controls Fig. 2 Ventilator Section Controls & Indicator LightsFig. 3 Cooktop Section Controls & Indicator Lights W.03 OPTIONAL WARMER SECTION CONTROLS VENTILATOR SECTION CONTROLSCOOKTOP SECTION CONTROLS CHECK FILTERS ALARM ELECTRIC SHOCK HAZARD RISK OF DAMAGE Indicators Fig. 5 Ventilator 504 p/n 303903 opM WV-4H Ventless Hotplate Cooktop 504 p/n 303903 opM WV-4H Ventless Hotplate Cooktop DANGER INSTALLATION continuedFIRE SUPPRESSION SYSTEM INSTALLATION FIRE HAZARD 504 p/n 303903 opM Fig. 7 Filter InstallationWV-4H Ventless Hotplate Cooktop SLIP / FALL HAZARD SPILLED OIL GREASE TROUGH AND GREASE CUP INSTALLATIONROLL WARMER INSTALLATION BURN HAZARD HOT SURFACE VENTILATOR OPERATIONOPERATION Fig. 9 Ventilator Indicator and Warning Lights Fig. 10 Hotplate Temperature Control OPERATION continuedHOTPLATE COOKTOP OPERATION GENERAL OPERATIONAL NOTES HOT SURFACE OPERATING CHART FOR DRAWER WARMERSDRAWER WARMER OPERATION Fig. 11 Roll Warmer Temperature Control PROCESS DRAWER WARMER OPERATION when providedPROCESS HOLD CLEANING INSTRUCTIONS FREQUENCY Weekly CLEANING INSTRUCTIONS continuedVENTILATOR WEEKLY CLEANING EXTERIOR VENTILATOR MONTHLY CLEANINGFREQUENCY Monthly DRAWER WARMER DAILY CLEANING MAINTENANCE SCHEDULES WELLS BLOOMFIELD,LLC WELLS BLOOMFIELD,LLC SECTION 1 - IDENTITY MATERIAL SAFETY DATA SHEETANSUL SECTION 2 - INGREDIENTS SECTION 5 - HEALTH HAZARDS SECTION 6 - EMERGENCY AND FIRST AID PROCEDURESSECTION 8 - SPECIAL PRECAUTIONS AND SPILL/LEAK PROCEDURES SECTION 7 - SPECIAL PROTECTION INFORMATION NOTE There are no user serviceable components in the appliance Wells Bloomfield, LLC SERVICE TRAINING - QUALITY SERVICE Genuin e PartsCommercial Food Equipment Service Association Commercial Food Equipment Service Association