3.Set the Right Handrail (33) on the console as- sembly. Make sure that the console wire is not pinched. Remove the tie from the bracket on the Right Handrail. If necessary, press the Cage Nut (110) back into place.

Start an M5 x 16mm Screw (85) with an M5 Star Washer (7) into the Right Handrail (33), and then start two M4.2 x 19mm Screws (10) into the Right Handrail. Tighten the M5 x 16mm

Screw and then tighten the two M4.2 x 19mm Screws; do not overtighten the Screws. Attach the Left Handrail (not shown) to the console assembly in the same way. Note: There is no wire on the left side.

4.With the help of a second person, hold the con- sole assembly near the Right Upright (54). Connect the Wire Harness (39) to the console wire. See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF YOU DO NOT CONNECT THE CON-

NECTORS PROPERLY, THE CONSOLE MAY BECOME DAMAGED WHEN YOU TURN ON THE POWER. If there is a wire tie on the Wire Harness, remove the wire tie. Insert the connec- tors and the excess wire downward into the Right Upright (54).

3

Console Wire

 

 

 

 

85

 

 

110

 

 

Bracket

7

33

10

 

 

 

 

Console

 

 

 

 

Assembly

 

 

 

4

 

 

 

 

 

 

Console

 

 

 

Assembly

 

 

 

Console

39

Console

Wire

39

 

Wire

 

54

 

5.Set the console assembly on the Uprights (53, 54). Make sure that no wires are pinched. Start four M8 x 15mm Bolts (8) with four M8 Star Washers (5) into the Uprights as shown. Do not tighten the Bolts yet.

5

Console Assembly

 

 

 

 

54

5

8

8

5

53

 

 

 

8

 

 

 

 

 

 

 

 

 

 

Page 8
Image 8
Weslo 831.24822.0 manual Console Wire 110 Bracket