MAINTENANCE AND TROUBLESHOOTING
Inspect and tighten all parts of the exercise cycle reg- ularly. Replace any worn parts immediately.
To clean the exercise cycle, use a damp cloth and a small amount of mild detergent. Important: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight.
BATTERY REPLACEMENT
If the console display becomes dim, the batteries should be replaced; most console problems are the result of low batteries. To replace the batteries, refer to step 5 on page 6 and remove the console from the handlebar. Next, refer to step 4 on page 5 and insert three batteries into the console. Reattach the console to the handlebar, being careful not to pinch the wires.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the reed switch should be adjusted. In order to adjust the reed switch, the left side shield must be removed.
52 |
24 |
21 |
54 |
17 |
52 |
Turn the Crank (21) to the position shown. Using an adjustable spanner, turn the Left Pedal (24) clockwise and remove it. Next, remove the five M4 x 25mm Screws (52) and the M4 x 19mm Screw (54) from the Left Side Shield (17). Carefully remove the Left Side Shield.
21 | 43 | 38 |
| 46 |
|
Next, locate the Reed Switch (43). Turn the Crank
(21)until the Magnet (38) is aligned with the Reed Switch. Loosen, but do not remove, the M4 x 12mm Screw (46). Slide the Reed Switch slightly closer to or away from the Magnet. Retighten the Screw. Turn the Crank for a moment. Repeat until the console dis- plays correct feedback. When the Reed Switch is cor- rectly adjusted, reattach the left side shield and the left pedal.
PULSE SENSOR TROUBLESHOOTING
Refer to step 3 on page 10.
11
