3.Whilst another person holds the Upright (13) in the position shown, connect the Upper Wire (36) to the Reed Switch Wire (43). Cut and remove the zip tie holding the Reed Switch Wire to the Frame (1). Next, connect the Resistance Cable (19) to the Lower Cable

(45) in the following way:

See drawing A. Press the small cylinder on the end of the Resistance Cable (19) into the hole in the con- nector on the Lower Cable (45). Pull the Resistance Cable up and slide it into the slot in the top of the connector.

See drawing B. Turn the Resistance Cable (19) until it is aligned with the slot in the connector, and press the Resistance Cable down into the connector. The Resistance Cable will lock into place.

Carefully pull the excess Upper Wire (36) out of the top of the Upright (13), push the excess Cable (19, 45) down into the Frame (1), and insert the Upright into the Frame. Be careful to avoid pinching the Wires and Cables. Next, align one of the adjustment holes in the Upright with the indicated hole in the Frame. Insert the Adjustment Knob (9) into the Frame and the Upright, and turn the Knob clockwise until it is tight. Make sure that the Knob is inserted through one of the adjustment holes in the Upright.

4.The Console (16) requires three 1.5V AA batteries; alkaline batteries are recommended. Insert three bat- teries into the battery compartment. Make sure that the batteries are oriented as shown by the mark- ings inside the battery compartment.

3

 

 

 

Be careful to

 

avoid pinching

 

the wires and

 

cables whilst

 

inserting the

 

Upright.

 

13

 

 

Adjustment

 

 

Holes

 

19

36

 

 

 

45

43

 

Zip Tie

 

 

Hole

 

1

9

 

 

 

A

B

19

Connector

 

19

 

 

 

 

 

Slot

Hole

 

Connector

 

 

45

Cylinder

 

4

 

 

Batteries

 

 

16

 

 

5

Page 5
Image 5
Weslo WLEVEX12920 user manual Be careful to, Avoid pinching, Wires, Cables whilst, Inserting, Upright