
MAINTENANCE AND STORAGE
Inspect and tighten all parts of the exercise cycle reg- ularly. The exercise cycle can be cleaned with a soft, damp cloth. To prevent damage to the console, keep liquids away from the console and keep the console out of direct sunlight.
CRANK ADJUSTMENT
If the arms of the |
| |
Crank (7) become |
| |
loose, they should |
| |
be tightened in | Slotted | |
order to prevent | ||
Crank Nut | ||
excessive wear. |
| |
Loosen the Hex | 14 | |
Crank Nuts (14) | ||
7 | ||
on the left arm of | ||
the Crank. Place |
| |
the tip of a stan- |
|
dard screwdriver in one of the slots in the slotted crank nut. Tap the screwdriver with a hammer to turn the slotted crank nut counterclockwise until the arms are no longer loose. Do not overtighten the slotted crank nut. When the slotted crank nut is properly tightened, tighten the Hex Crank Nuts.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the reed switch may need to be adjusted. To adjust the reed switch, you must first remove the Left Side Shield
(20). Using |
|
|
| |
an adjustable |
|
|
| |
wrench, turn | 39 | 7 | 20 | |
the Left | ||||
|
|
| ||
Pedal (39) |
|
|
| |
clockwise |
|
|
| |
and remove |
|
|
| |
it. Next, |
|
|
| |
remove the |
|
|
| |
indicated #8 |
|
|
| |
x 1/4Ó |
|
|
| |
Screws (22). |
|
| 22 | |
Grasp both |
|
| ||
Side Shields |
|
|
| |
and gently |
|
|
|
pull them apart. Turn the left arm of the Crank (7) to the position shown, and then carefully slide the Left Side Shield forward and remove it.
With the left side shield removed, locate the Reed Switch (42) (see the drawing below). Turn the Crank
(7)until the Magnet (61) is aligned with the Reed Switch. Loosen but do not remove the #8 x 1/2Ó Screw (43). Slide the Reed Switch slightly closer to or away from the Magnet. Retighten the Screw. Turn the Crank for a moment. Repeat until the console dis- plays correct feedback. When the Reed Switch is cor- rectly adjusted, reattach the left side shield and the left pedal.
61 | 42 | 7 |
| 43 |
|
View from the Front |
BATTERY REPLACEMENT
If the console does not function properly, the batteries should be replaced. See assembly step 7 on page 7.
12