Weslo WLTL 13921 user manual Maintenance and Troubleshooting, Symptom the Walking Belt does not

MAINTENANCE AND TROUBLESHOOTING

Most problems can be solved by following the simple steps below. If further assistance is needed, call our Customer Service Department toll-free at 1-800-999-3756, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays).

1. SYMPTOM: THE CONSOLE DOES NOT			3. SYMPTOM: THE WALKING BELT SLIPS OR IS
FUNCTION PROPERLY			OFF-CENTER
a. Replace the batteries in the console (see assem-			a. If the walking
bly step 5 on page 5).			belt slips
			when walked
b. Make sure that the reed switch is properly adjust-			on, use the
ed (see assembly step 4 on page 5).			allen wrench to
			turn both
c. Make sure that the reed switch wire is plugged			adjustment
fully into the back of the console (see assembly			bolts clockwise,
step 3 on page 4).			1/4 of a turn. When the walking belt is correctly
			tightened, you should be able to lift each side of
d. The console, like most electronics, is susceptible			the walking belt 2 to 3 inches. Walk on the tread-
to static electricity build-up caused by certain			mill for a few minutes. Repeat until the walking
types of clothing or by the operation of the tread-			belt is properly tightened. Be careful to keep the
mill. If the display is blank or gives incorrect read-			walking belt centered.
ings, apply an anti-static spray to the handrail.
Anti-static spray is available where laundry sup-			b. If the walking
plies are sold.			belt has shift-
			ed to the left
2. SYMPTOM: THE WALKING BELT DOES NOT			side, use the
MOVE SMOOTHLY			allen wrench to
			turn the left
a. If the walk-			adjustment bolt
ing belt is		Walking Belt	clockwise, and
overtight-			the right adjustment bolt counterclockwise, 1/4 of
ened, per-			a turn each. Be careful not to overtighten the
formance			walking belt. Walk on the treadmill for a few min-
may be			utes. Repeat until the walking belt is centered.
reduced and	2"–3"
the walking		Bolts	c. If the walking
belt may be			belt has shift-
permanently			ed to the right
damaged. Using the allen wrench, turn both rear			side, use the
roller adjustment bolts counterclockwise 1/4 of a			allen wrench to
turn. When the tension of the walking belt is cor-			turn the left
rect, you should be able to lift each side of the			adjustment bolt
walking belt 2 to 3 inches. Walk on the treadmill			counterclock-
for a few minutes. Repeat until the walking belt is			wise, and the right adjustment bolt clockwise, 1/4
properly tightened. Be careful to keep the walking			of a turn each. Be careful not to overtighten the
belt centered.			walking belt. Walk on the treadmill for a few min-
			utes. Repeat until the walking belt is centered.

8