Western Telematic IPS-800-CE Installation, Power Supply Connection, Installing the Cable Keepers

Models: IPS-1600 IPS-800 IPS-800, IPS-800-CE, IPS-1600, IPS-1600CE IPS-800-CE

1 60
Download 60 pages 19.96 Kb
Page 17
Image 17

4. Installation

This Section provides further details regarding installation of the IPS unit.

4.1. Power Supply Connection

Use the supplied power cords to connect the IPS unit to an appropriate power supply. Note that the IPS’s Master Power Switch must be "On" in order for the unit to operate.

CAUTIONS:

Before attempting to install this unit, please review the warnings and cautions listed at the front of the user's guide.

This device should only be operated with the type of power source indicated on the instrument nameplate. If you are not sure of the type of power service available, please contact your local power company.

Reliable earthing (grounding) of this unit must be maintained. Particular attention should be given to supply connections when connecting to power strips, rather than directly to the branch circuit.

4.1.1.Installing the Cable Keepers

The IPS includes cable keepers, which are designed to prevent the power supply cables from being accidentally disconnected from the unit.

IPS-1600 and IPS-1600-CE:Sixteen-plug units include pre-installed cable keepers. When attaching the power supply cables to the unit, first swing the cable keepers out of the way, then plug the power cables securely into the power inputs. When the cables are in place, snap the cable keepers over each plug to secure the cables to the unit.

IPS-800 and IPS-800-CE:The cable keeper for eight-plug units must be installed by the user. First make certain that both of the IPS's two power cables are disconnected from your power supply. Next, loosen (but do not remove) the retaining screws located adjacent to the power inlets. Connect the power supply cables to the IPS power inlets, then slip the cable keepers under each supply cable so the notches at the top of the keeper line up with each cable, and the two slots on the bottom of the keeper slide under the loosened retaining screws. Tighten the retaining screws to secure the cable keeper to the unit, make certain that the cables are secure, and then connect the cables to your power supply.

4-1

Page 17
Image 17
Western Telematic IPS-800-CE, IPS-1600 manual Installation, Power Supply Connection, Installing the Cable Keepers