IPS-800/IPS-1600 Series - User’s Guide
Internet Power Switch v1.40h | Site ID: (undefined) |
| ||||
Display | Display Help Screen |
|
| Configuration | ||
/H |
|
|
| /G | View/Set General Parameters | |
/S |
| Display Plug Status |
|
| /P [n] | View/Set Plug Parameters |
/SN |
| Display Network Status |
| /C | View/Set Serial Parameters | |
Control |
|
|
| /N | View/Set Network Parameters | |
|
|
| /T | View/set Telnet Parameters | ||
/Boot <n> Boot Plug n |
|
| /W | View/Set Web Server | ||
/On <n> | Turn On Plug n |
|
| /E | Save Parameters | |
/Off <n> | Turn Off Plug n |
|
| /R | Recall Parameters | |
/X |
| Exit/Disconnect |
|
| /DL | Download Parameters to File |
|
| + | Utilities | Reset Network Interface | ||
[n] = | optional plug name or number | /I | ||||
<n> = | required plug name or number | /U | Upgrade Firmware | |||
n+n or n n = plug n and plug n |
|
|
| |||
n:n = | plug n through plug n |
|
|
| ||
* | = | all plugs |
|
|
| |
,y | = | bypass “Sure? (y/n)” |
|
|
| |
|
| + |
|
|
IPS>
Figure 6.3: The IPS Help Screen - Text Interface
6.2.2.Boot/On/Off Commands - Text Interface
These commands can Boot or toggle the IPS’s switched plugs. Plugs may be specified by name or number.
Notes:
•Wait for the "IPS>" prompt to appear before entering commands. The prompt will not reappear until the previous command is complete.
•Commands are not case sensitive. All commands are invoked by pressing [Enter].
•Users who login to command mode using a Plug password, will only be allowed to issue commands to the plugs allowed by that password.
•If command confirmation is enabled, the IPS will display the Status Screen after the Boot/On/Off commands are successfully completed.
•When Boot/On/Off operations are initiated, Boot/Sequence Delay times will be applied as described in Section 5.3.3.2.
To Switch Plugs, or initiate a Boot Cycle, proceed as follows:
1.Switch Plug(s) On: To
For example: