Q-Logic FC HBA CLI manual View or Toggle Beacon Status, 2defines the command variables

5– Non-interactive Commands Command Summary

S

„You can use either the hyphen (-) character or the forward slash (/) character. For example, both of these commands are valid:

scli -g scli /g

Table 5-2defines the command variables.

	.
	Table 5-2. Command Variables
Variable		Definition	Format
<HBA Instance> or		HBA numbera
<Instance number>
<HBA WWPN>		HBA world wide port name	xx-xx-xx-xx-xx-xx-xx-xx or
			xxxxxxxxxxxxxx
<Alias>		HBA Alias	Symbolic HBAb name
<Target WWNN>		Target world wide node	xx-xx-xx-xx-xx-xx-xx-xx or
		name	xxxxxxxxxxxxxx
<Target WWPN>		Target world wide port	xx-xx-xx-xx-xx-xx-xx-xx or
		name	xxxxxxxxxxxxxx
<Target Port ID>		Target port ID	xx-xx-xx or xxxxxx
<Target ID>		Target ID
<LUN ID>		Logical unit number	(0–255)
<Address>		IP Address	xxx.xxx.xxx.xxx
(speed)		Target link speed	1.2 or 4 GHz

aYou can use the -g command to find HBA numbers.

bYou assign the symbolic name. It is limited to 100 characters in length.

5.3.1

-a

(View or Toggle Beacon Status)

Use the -acommand to either view (1) or change (2) the status of a beacon.

NOTES:

„HBA must not be in silent mode. See section 5.3.28 to issue a response to this command.

„The -afeature is not supported on QLA22xx HBAs.

5-6 SN0054614-00 F