Q-Logic FC HBA CLI manual Beacon Selected Targets, Diagnostics Menu

4 – Interactive Commands

Diagnostics Menu (Command Line Options -kl, -kr, and -dm)

S

You can select a disk number to blink the LED on that target. The blinking asterisk (*) below the Device Port Name line shows that the target beacon is active.

------------------------------------------------------------------------------

HBA Instance 1: 2200 Port 2 WWPN 21-01-00-E0-8B-23-55-7C PortID 11-06-00

------------------------------------------------------------------------------

Target Beacon

--------------------------------------------------

Hit <RETURN> to abort

--------------------------------------------------

Device Port Name	Beacon Status
21-------------------------00-00-20-37-11-FF-EF	-------------
	On - Active

*

4.11.2.1

Beacon Selected Target(s)

11: Beacon 2: Locate Target(s) 3: Beacon Selected Target(s)

When you select the Beacon Selected Target(s) option, SANsurfer FC HBA CLI shows a list of the targets associated with the HBA. You can select any target to toggle the Beacon LED for that target:

4.12

Diagnostics Menu

(Command Line Options -kl, -kr, and -dm)

12: Diagnostics

When you select this option from the Main Menu, SANsurfer FC HBA CLI shows Diagnostics Menu with the standard list of HBA ports. Select the port you want to run diagnostic tests on, type its number, and then press ENTER.

NOTE:

–exclude –exignores this device in a read/write buffer test.

Table 4-9shows the diagnostics configuration settings.

Table 4-9. HBA Diagnostics Configuration Settings

Parameter Name	Alias <param	Value <param value>	Description
<param name>	alias>
DataPattern	DP	00–FF	See table note 1
		CRPAT	See table note 1
		CSPAT	See table note 1

4-62 SN0054614-00 F