Q-Logic FC HBA CLI manual Interactive Commands

Section 4

Interactive Commands

This section describes the interactive mode command line options for specific QLogic FC HBAs. The interactive mode uses a series of menus from which you select the option you want and enter the number for that option. (See Section 5 for non-interactive mode operation in which you simply enter a one- or two-letter code to perform operations on the HBA.)

To start the interactive mode, type one of the following:

[ scli ]

[ scli int] (on some Solaris installations)

When you start SANsurfer FC HBA CLI in interactive mode, the Main Menu appears as follows:

Main Menu

1:General Information

2:HBA Information

3:HBA Parameters

4:Target/LUN List

5: Target Link Speed or 5: iiDMA Settings

6:Target Persistent Bindings

7:Selective LUNs

8:Boot Device

9:Driver Settings

10:Utilities

11:Beacon

12:Diagnostics

13:Statistics

14: Help	or	14: Virtual (if available)
15: Exit	or	15: Help
	or	16: Exit

NOTE:

Selections on the Main Menu may differ, depending on your system:

„Selection 5: may be either Target Link Speed or iiDMA Settings.

„The Virtual menu selection is available only on Windows systems running with a driver that supports NPIV (N_Port ID Virtualization).

SN0054614-00 F 4-1