Q-Logic FC HBA CLI manual Command Summary, Only, Command format for non-interactive mode is

A

5– Non-interactive Commands Command Summary

Table 5-1. Options Shown by -z (Continued)

CLI	Description	See Section
-i	Show HBA information (VPD information for QLA/QLE24xx	5.3.15
	only)
-l	Show LUN list	5.3.19
-m	Configure selective LUNs	5.3.21
-p	Configure target persistent binding	5.3.24
-t	Show target list	5.3.29

5.3

Command Summary

The command format for non-interactive mode is:

#scli -(Cmd) (<HBA Instance> <HBA WWPN>) (view ?)

Where:

HBA Instance = HBA port instance (use -g command to find)

HBA WWPN = HBA World wide port name

You can combine the commands -o, -sand -xwith other options. However, they must be at the beginning or at the end of the command line. Use these commands as follows:

„-o= Output the results to a file (see section 5.3.23). For example:

#scli -l -o

„-s= Silent mode (see section 5.3.28). For example:

#scli -i all -s -o output.txt

„-x= Outputs the results in XML format (see 5.3.34). For example:

#scli -i all -x -o output.xml

You cannot combine the command -fwith any other options:

„-f= Input Parameter Options from a Text File (see section 5.3.8). For example:

# scli -fcommand.txt

In addition, the following general rules for commands apply:

„Only one command line option per input file is valid.

SN0054614-00 F 5-5