Q-Logic FC HBA CLI manual Data Pattern DP Test Patterns, „ Status

A

5– Non-interactive Commands Command Summary

bComplaint random data pattern in a valid FC frame, as defined by the ANSI document Methodologies for Jitter and Signal Quality Specification - MJSQ Annex A - Test bit sequences.

cComplaint jitter tolerance pattern in a FC frame, as defined by the ASIC document listed above.

dSupply noise test sequence in a valid FC frame, as defined by the ASIC document listed above.

eFor read/write buffer test, the maximum size is 128; this is also the default. For an echo test, the maximum size is 2048; the default size is 512. For a loopback test on Windows, Solaris, and Macintosh systems, the maximum size is 2048; the default size is 512. For a loopback test on Linux OSs, the maximum size is 65535; the default size is 512.

f0=test continuously. 1–10,000 and 1–65535=total number of tests that will be executed.

gMust be less than the TestCount value.

Table 5-9. Data Pattern (DP) Test Patterns

Hex	Binary
00	00000000
55	01010101
5A	01011010
A5	10100101
AA	10101010
FF	11111111

If the read/write buffer test fails, the system shows the following information:

„Loop/port ID (the loop ID of the HBA when operating in loop mode).

„Status:

‰Success – The test passed.

‰Error – A data miscompare or link status firmware error occurred.

‰Failed – A link status error, SCSI write buffer error, or SCSI read buffer error occurred.

‰Unknown – The target was not present.

‰Unsupported – The device does not support this test.

„Data Miscompare. The possible values are:

‰0 (no data miscompares)

‰Device not present

‰Get link status failed

‰Read buffer failed

‰R/W buffer not supported

SN0054614-00 F 5-27