Q-Logic FC HBA CLI manual Options Shown by -z, Description See Section

5 – Non-interactive Commands

Display System Information (Command Line Options -g, -z, and -tp)

S

‰Port State

„Port Information

‰Physical Port Number (switch port number), including:

‰Port state

‰Port type

‰TX port type

‰Port module type

‰Attached Port (QLogic HBA, tape device, or disk device connected to the switch physical port), including:

‰Target/initiator

‰Node name

‰Port name

‰Vendor ID

‰Product ID (if applicable)

‰Product revision (if applicable)

‰Product serial number (if applicable)

‰HBA model (if applicable)

‰HBA serial number (if applicable)

‰HBA alias (if applicable)

‰Port alias (if applicable)

‰Driver version

‰Firmware version

‰Total number of devices (if applicable)

‰Host (if applicable)

5.2.4

Host Configuration

Use these options to show the information for one or all of the HBA ports in the system. The -zoption shows the combination of the commands listed in Table 5-1. The commands are listed in alphabetical order.

	.
	Table 5-1. Options Shown by -z
CLI	Description	See Section
-c	Show HBA settings	5.3.3
-e	Configure boot device	5.3.6
-fg	View driver settings	5.3.9
-g	Show system information	5.3.11

5-4 SN0054614-00 F