Q-Logic FC HBA CLI manual Errordiagnosticsdatamiscompare

A

D – Non-interactive Error Codes

Table D-1. Error Code Descriptions – Non-interactive Mode (Continued)

Code	Name	Description
41	ERROR_DIAGNOSTICS_LOOP_DOWN	Unable to run diagnostics because the
		loop is down
42	ERROR_DIAGNOSTICS_FAILURE	Diagnostics test failed with errors
43	ERROR_DIAGNOSTICS_DATA_MISCOMPARE	Diagnostics test failed with data mis-
		compare
44	ERROR_DIAGNOSTICS_UNKNOWN_STATUS	Unknown diagnostic test status
45	ERROR_DIAGNOSTICS_NO_AVAIL_TARGET	Unable to run R/W buffer test because
		there are no attached devices
46	ERROR_DIAGNOSTICS_NOT_FOUND_TARGET	Unable to run R/W buffer test because
		the excluded device is not available
47	ERROR_DIAGNOSTICS_MAX_FRAME_SETTING	Unable to run diagnostics because of
		the HBA current frame size setting
48	ERROR_INVALID_DIAGNOSTICS_SETTINGS	Invalid diagnostics test parameter set-
		tings
49	Reserved	Not used
50	ERROR_FC_LINK_UNKNOWN_STATUS	Error getting FC link status
51	ERROR_RESET_LINK_STATUS	Unable to reset HBA link status
52	ERROR_INVALIDE_STATISTICS_PARAMS	Invalid link status/statistics parameter
		settings
53	Reserved	Not used
54	Reserved	Not used
55	Reserved	Not used
56	Reserved	Not used
57	Reserved	Not used
58	Reserved	Not used
59	Reserved	Not used
60	ERROR_INVALID_PARAM_SETTINGS	Invalid HBA parameter value/key
61	ERROR_PARAM_UNSUPPORTED_HBA	Specified HBA parameter is not sup-
		ported
62	ERROR_PARAM_UNSUPPORTED_DRIVER	Unable to update HBA parameters –
		Driver unsupported

SN0054614-00 F D-3