•File size %d is too big, max is %d
•Invalid %s
•Failed writing 0x%x to 0x%x
•*1
•*1
•*1
•*1
•Cannot perform task while chip is not running. (need driver)
•Cannot open register define file or content is bad
•ASF Reset bit did not
•ATTN_LOC %d cannot be mapped to %cX CPU event bit %d
•%s Register is not cleared to zero after reset
•Cannot start Register Timer
•poll_ASF bit did not get reset after acknowledged
•Timestamp Counter is not counting
•%s Timer is not working
•Cannot clear bit %s in %cX CPU event register
•Invalid "EEPROM_FILENAME" file size, expected %d but only can read %d bytes
•Invalid magic value in %s, expected %08x but found %08x
•Invalid manufacture revision, expected %c but found %c
•Invalid Boot Code revision, expected %d.%d but found %d.%d
•Cannot write to EEPROM
•Cannot read from EEPROM
•Invalid Checksum
•Invalid Magic Value
•Invalid MAC address, expected
•Slot error, expected an UUT to be found at location %02X:%02X:00
•Adjacent memory has been corrupted while testing block
•Got 0x%08x @ address 0x%08x. Expected 0x%08x
•*1 Internal Use. Program will not generate this error.
HP NC-Series Intel adapter diagnostics
1.Boot to DOS or the EFI shell.
2.From the DOS prompt navigate to the \APPS\DIAGS\N100X directory.
Diagnostics 60