Locally Administered Address. Specifies the user-defined MAC Address of the adapter, which overrides the burned-in MAC Address. This box is disabled if the selected adapter has been teamed. o Default = Not Present

o Range: Value; Not Present

Log Link State Event. Enables or disables the logging of link state changes. If enabled, a link up change event or a link down change event generates a message that is displayed in the system event logger.

o Default = Enabled

o Range = Disabled; Enabled

Priority and VLAN. Enables or disables the ability to insert or remove the 802.1q tags for priority and VLAN.

o Default = Priority & VLAN Enabled

o Range = Priority & VLAN Disabled; Priority & VLAN Enabled; Priority Enabled; VLAN Enabled

Receive Buffers. The size, in bytes, of the receive buffers that the hardware can support. This size is hardware-dependent and can include data buffers, buffer descriptors, and so on.

o Default = 256

Smart Power Down. (NC110T, NC360x, and NC364T only) Minimizes power consumption by enabling the adapter to enter a deep sleep mode under certain conditions.

o Default = Hardware Default

o Range = Disabled; Enabled; Hardware Default

TCP Checksum Offload (IPv4). Describes whether the device enabled or disabled the calculation of TCP Checksum over IPv4 packets.

o Default = Rx/Tx Enable

o Range = Disable; Tx Enable; Rx Enable; Rx/Tx Enable

TCP Checksum Offload (IPv6). Describes whether the device enabled or disabled the calculation of TCP checksum over IPv6 packets.

o Default = Rx/Tx Enable

o Range = Disable; Tx Enable; Rx Enable; Rx/Tx Enable

Transmit Buffers. The size, in bytes, of the transmit buffers that the hardware can support. This size is hardware-dependent and can include data buffers, buffer descriptors, and so forth.

o Default = 512 Bytes

UDP Checksum Offload (IPv4). Describes whether the device enabled or disabled the calculation of UDP checksum over IPv4 packets.

o Default = Rx/Tx Enable

o Range = Disable; Tx Enable; Rx Enable; Rx/Tx Enable

UDP Checksum Offload (IPv6). Describes whether the device enabled or disabled the calculation of UDP checksum over IPv6 packets.

o Default = Rx/Tx Enable

o Range = Disable; Tx Enable; Rx Enable; Rx/Tx Enable

Wait for Link. Determines if the driver waits for auto-negotiation to be successful before reporting the link state. If disabled, the driver does not wait for auto-negotiation. If enabled, the driver does wait

Adapter configurations 37

Page 37
Image 37
HP 441877-00F manual Adapter configurations