Q-Logic FC HBA CLI manual Configuring the iiDMA Settings, Target Link Speed Settings

A

4 – Interactive Commands Target Link Speed or iiDMA Settings Menu (Command Line Option -q)

8.All HBAs

9.Return to Previous Menu

Table 4-3lists the target link speed settings and descriptions.

Table 4-3. Target Link Speed Settings

Target Link Speed Settings	Description
<address>	IP Address.
<hba instance>	HBA number (HBA instance number).
<hba wwnn>	HBA World Wide Port Name, format
	xx-xx-xx-xx-xx-xx-xx-xx or xxxxxxxx.
<lun id>	Logical Unit Number (0–255),
<speed>	Target Link Speed (iiDMA) - (1, 2, or 4 Gbs).
<target id>	Target ID.
<target portid>	Target World Wide Port Name, format xx-xx-xx
	or xxxxxx.
<target wwnn>	Target World Wide Node Name, format
	xx-xx-xx-xx-xx-xx-xx-xx or xxxxxxxx.
<target wwpn>	Target World Wide Port Name, format
	xx-xx-xx-xx-xx-xx-xx-xx or xxxxxxxx.
-targets -t	All targets.

4.5.1

Configuring the iiDMA Settings

Use the Intelligent Interleave Factor Selection (iiDMA) menu to select the intelligent interleave factor settings per HBA type and device.

To configure iiDMA settings:

1.From the SANsurfer FC HBA CLI main menu, select iiDMA Settings.

2.Select the HBA that you want to apply the Intelligent Interleave factor update.

3.Select one of the following options:

‰Basic Configuration if you want to apply the Intelligent Interleave factor update to all devices attached to this adapter.

‰Advanced Configuration if you want to select an apply different Intelligent Interleave factor update to each device attached to this adapter.

SN0054614-00 F 4-39