Q-Logic FC HBA CLI Show Driver Settings, Configure Driver Settings, Driver Settings Parameters

A

5– Non-interactive Commands Command Summary

5.3.9

-fg

(Show Driver Settings)

NOTE:

The -fgoption is valid only in non-interactive mode.

To show the driver settings, type:

#scli -fg (<HBA Instance> <HBA WWPN>) (view ?)

Where:

HBA Instance = HBA number (use -gcommand to find)

HBA WWPN = World wide port name of the HBA

5.3.10

-fs

(Configure Driver Settings)

Type the following command to configure the driver settings:

#scli -fs (<HBA Instance> <HBA WWPN>) {(<Parameter Name> <Parameter Alias>) <Param Value>}

Where:

HBA Instance	= HBA instance number of an HBA port (use -gcom-
	mand to find)
HBA WWPN	= World wide port name of the HBA
Parameter Name	= Name of the parameters
Parameter Alias	= Alias of the parameters
Parameter Value	= New value of the parameters

The pairs <Parameter Name> <Parameter Value> and <Parameter Alias> <Parameter Value> can be repeated to set multiple parameters in a single command.

Table 5-3lists the driver configuration parameter names and aliases.

Table 5-3. Driver Settings Parameters

	Parameter Name	Alias	Valuea
Description		<param	<param
	<param name>
		alias>	value>
Persistently bound target(s) only	PersistentOnly	PO	0, 1

SN0054614-00 F 5-13