Q-Logic FC HBA CLI manual Display System Information, Show HBA Statistics

5– Non-interactive Commands Command Summary

S

Table 5-3. Driver Settings Parameters (Continued)

	Parameter Name	Alias	Valuea
Description		<param	<param
	<param name>
		alias>	value>
Present persistently bound tar-	PersistentPlusNew	PN	0, 1
get(s) plus any new target(s) with
driver default
Present targets with driver default	NewOnlyb	NO	0, 1
Bind devices by WWPN	BindWWPN	BW	0, 1
Bind devices by port ID	BindPortID	BP	0, 1

Table Notes

a0 = Disabled, 1 = Enabled

bDriver parameter NewOnly (NO) is supported only with the failover driver. If you select a QLA22xx HBA, all QLA22xx HBAs on the host will use the same settings. If you select a 23xx HBA, all 2G/4G HBAs on the host will also use the same settings.

The following restrictions apply:

„Under Solaris, the driver configuration feature is disabled if you are using the driver from the OS installation CDs (QLC driver).

„Under Linux, this feature is disabled if you are using the ioctl or sysfs (inbox) driver.

„Under Macintosh, the BindWWPN and BindPortID parameters are not changeable; Mac supports only the BindWWPN parameter.

5.3.11

-g

(Display System Information)

To view system information, type:

#scli -g

For details of this command, see section 5.2.

5.3.12

-gs

(Show HBA Statistics)

To view the HBA statistics, type:

#scli -gs(<HBA Instance> <HBA WWPN>) [(<Parameter Name> <Parameter Alias>) <Parameter Value>]

5-14 SN0054614-00 F