Q-Logic FC HBA CLI manual To view all selective LUNs for all HBA ports, type

5– Non-interactive Commands Command Summary

S

„Disable (deselect) a LUN on a specific target on a specific HBA (5)

„Enable all LUNs on a specific target on a specific HBA (6)

„Disable (deselect) all LUNs on a specific target on a specific HBA (7)

„Enable (select) all LUNs of all targets on a specific HBA (8)

„Disable (deselect) all LUNs of all targets on a specific HBA (9)

For these commands:

HBA Instance = HBA number (use -gcommand to find)

HBA WWPN = World wide port name of the HBA

Target WWNN = World wide node name of the target

Target WWPN = World wide port name of the target

LUN ID = ID of the LUN

To view all selective LUNs for all HBA ports, type:

#scli -m all (view ?)

To view an HBA’s selective LUN list, type:

#scli -m (<HBA Instance> <HBA WWPN> all) (view ?)

In Solaris SPARC, include double quotes around the question mark (?) if the system is running with a csh or tsch shell. For example:

#scli -m <HBA> "?"

SANsurfer FC HBA CLI shows the HBA’s enabled LUN list in the following format:

<Target WWNN> <Target WWPN> <LUN ID>

To view the current select state of a specific LUN, type:

#scli -m (<HBA Instance> <HBA WWPN>) (<Target WWNN> <Target WWPN> <LUN ID>) (view ?)

If the input represents a valid LUN, SANsurfer FC HBA CLI shows that LUN’s current state as selected or deselected for that HBA.

To enable (select) a LUN on a specific target on a specific HBA, type:

#scli -m (<HBA Instance> <HBA WWPN>) {<Target WWNN> <Target WWPN> <LUN ID> ( 1 enable select )}

NOTE:

You can repeat the sequence <Target WWNN> <Target WWPN> <LUN ID> 1 to select multiple LUNs in the same command.

To disable (deselect) a LUN on a specific target on a specific HBA, type:

5-30 SN0054614-00 F