Q-Logic FC HBA CLI manual Loop Reset Delay, Enable HBA Port Bios, Enable HBA Hard Loop ID

4 – Interactive Commands HBA Parameters Menu

S

„Frame Size: 512

„Frame Size: 1024

„Frame Size: 2048

Type the number for the frame size you want and press ENTER.

4.3.1.2.4

Hard Loop ID

3: HBA Parameters N: Port Number 2: Configure HBA Parameters n. Hard Loop ID

This option prompts you to enter a valid Hard Loop ID from 0 to 125. Type the number you want and press ENTER.

4.3.1.2.5

Loop Reset Delay

3: HBA Parameters N: Port Number 2: Configure HBA Parameters n. Loop Reset Delay

This option prompts you to enter a Reset Delay from 0 to 255 seconds. Type the number you want for the loop reset delay and press ENTER.

4.3.1.2.6

Enable HBA Port BIOS

3: HBA Parameters N: Port Number 2: Configure HBA Parameters n. Enable HBA Port BIOS

This option allows you to enable or disable the BIOS boot setting. When this setting is disabled, the ROM BIOS on the HBA is disabled. If you are booting from a FC hard disk attached to the HBA, you must enable this setting. The default is disabled.

4.3.1.2.7

Enable HBA Hard Loop ID

3: HBA Parameters N: Port Number 2: Configure HBA Parameters n. Enable HBA Hard Loop ID

This choice gives you the option to enable or disable the Hard Loop ID. Type the number you want and press ENTER.

4.3.1.2.8

Enable Fibre Channel Tape Support

3: HBA Parameters N: Port Number 2: Configure HBA Parameters n. Enable Fibre Channel Tape Support

This choice gives you the option to enable or disable Fibre-Channel Tape support. Type the number you want and press ENTER.

4-26 SN0054614-00 F