Whirlpool 1188177 manual Display Symbols Fan Speed, Exhaust Air, Mode, Temperature, Timer Delay

Display Symbols

Fan Speed

A B

F G

A. Cool mode indicator light

B. Fan only mode indicator light

C. Heat indicator light (on some models)

D. Power Saver indicator light

C D E

HI

E.Timer indicator light

F.Auto fan mode indicator light

G.Low fan mode indicator light

H.High fan mode indicator light

I.Turbo fan mode indicator light

1.Press FAN SPEED until you see the indicator light come on for the setting you desire.

2.Choose Auto, Low, High or Turbo.

When Auto is selected, the fan speed will change automatically as the temperature in the room changes.

■7º or more above the set temperature will use Turbo.

■4º - 7º above the set temperature will use High.

■4º or below the set temperature will use Low.

Exhaust Air

The Exhaust Air feature allows the air conditioner to either recirculate inside air (CLOSED) or exhaust air to the outside (OPEN).

■CLOSED—used when maximum cooling is desired. It may also be used for air recirculation without cooling when the air conditioner is set to Fan mode.

■OPEN—removes stale air from the room and exhausts it to the outside.

NOTE: The OPEN or CLOSED position can be used with any mode selection.

Mode

1.Press MODE until you see the indicator light come on for the setting you desire.

2.Choose Cool, Heat (on some models), Fan Only or Power Saver.

■Cool—Cools room. Press FAN SPEED to choose fan speed. Then adjust the temperature by pressing the plus or minus buttons.

■Heat (on some models)—The unit will circulate and heat the air.

When heater is powered off, Low fan will automatically stay on and run for 30 seconds.

■Fan Only—Operates the fan at Low, High or Turbo speed, without cooling. Display will show the current room temperature.

■Power Saver—The fan will switch off whenever the compressor turns off in response to the set temperature. When the compressor cycles back on, the fan will return to the set fan speed.

Temperature

Press the TEMP plus pad. Display shows the Temperature control setting. Each time you press or hold the plus button, the temperature will increase 1º until it reaches 88°F (31ºC).

NOTE: After 3 seconds, display will show the set room temperature.

Press the TEMP minus pad. Display shows the Temperature control setting. Each time you press or hold the plus button, the temperature will decrease 1º until it reaches 66°F (19ºC).

NOTE: After 3 seconds, display will show the set room temperature.

To change the temperature display from ºF to ºC

Press both pads at once to switch the display from ºF to ºC.

Timer Delay

To set Timer for a 0.5- to 24-hour delay before air conditioner turns Off (air conditioner must be On):

1.Press TIMER. Timer indicator light will remain on. Display will show remaining hours before air conditioner will turn off.

2.Press the plus or minus pad to change the delay time from 0.5 to 24 hours.

3.Press TIMER again or wait 10 seconds. Timer indicator light will remain on. Display will show remaining hours before air conditioner will turn off.

4.To turn Timer off, press TIMER again, or press POWER to turn off the air conditioner.

10