15
Washer not performing as expected (cont.)
If you experience Possible causes Solution
First try the solutions suggested here or visit our website at www.whirlpool.com/help
for assistance and to possibly avoid a service call.
Incorrect or wrong
wash or rinse
temperatures
Check for proper water supply. Make sure hot and cold inlet hoses are not reversed.
Both hoses must be attached to both washer and faucet, and
have both hot and cold water owing to inlet valve.
Check that inlet valve screens are not clogged.
Remove any kinks in hoses.
Load not rinsed Check for proper water supply. Make sure hot and cold inlet hoses are not reversed.
Both hoses must be attached and have water owing to the
inlet valve.
Both hot and cold water faucets must be on.
Inlet valve screens on washer may be clogged.
Remove any kinks in the inlet hose.
Washing many loads. Your hot water tank may not have enough hot water to keep up
with the number of hot or warm washes. This is normal.
TROUBLESHOOTING
Not using correct cycle for fabric type. Use Heavy Duty cycle for tough cleaning.
Washer not loaded as recommended.
Not cleaning or
removing stains Add load loosely. Items need to move freely for best cleaning.
See the “Cycle Guide” for load size recommendations for each
cycle.
Add only 1 or 2 garments after washer has started.
Not using HE detergent or using too
much HE detergent. Use only HE detergent. Always measure detergent and follow
manufacture’s directions based on load size and soil level.
The suds from non-HE detergent can cause a lm residue.
Hard water or high level of iron (rust)
in water.
You may need to install a water softener and/or iron lter.
Fabric softener dispensing ball used. Dispensing balls will not operate correctly with this washer.
Add liquid fabric softener to the fabric softener compartment.
Powdered detergent used for
low-speed cycle. Consider using liquid detergent.
Load is wrinkled,
twisted, or tangled The washer is tightly packed. Add load loosely. Items need to move freely reduce
wrinkling and tangling. See the “Cycle Guide” for load size
recommendations for each cycle.
Reduce tangling by mixing types of load items. Use the
recommended cycle for the type of garments being washed.
Select a slower spin speed. Note that items will be wetter than
when using a higher speed spin.
Wash action and/or spin speed too
fast for load.
Unload the washer as soon as it stops.
The washer is not unloaded promptly.
Use the Delicate cycle or another cycle with a low spin speed
to reduce wrinkling.
Not choosing the right cycle for the
load being washed.
If safe for load, use warm or hot wash water.
The wash water was not warm
enough to relax wrinkles.
Washer not loaded as recommended. Avoid tightly packing the washer. The washer will not rinse well
if tightly packed. Load with dry items only. See the “Cycle
Guide” for load size recommendations for each cycle.
Use cycle designed for the fabrics being washed.
Add only 1 or 2 garments after washer has started.
Not using HE detergent or using too
much HE detergent.
The suds from regular detergent can cause the washer
to operate incorrectly.
Use only HE detergent. Always measure detergent and follow
manufacturer’s directions based on load size and soil level.