9
WASHER MAINTENANCE
10. Remove garments promptly
after cycle is nished
Promptly remove garments after cycle has completed to
avoid odor and rusting of metal objects on garments. When
unloading garments, pull back the door seal and check for
small items between the tub and the basket.
NOTE:
n
After any wash cycle is completed, the door must be opened
and then closed before a new cycle can begin.
n
A small amount of water may remain in the dispensers after
the wash cycle is complete. This is normal.
n This washer has a tight seal to avoid water leaks. To avoid
odors, leave the door open to allow the washer to dry
between uses.
CLEANING YOUR WASHER
Keep your washer as clean and fresh as your clothes.
To keep washer interior odor-free, follow this recommended
cleaning procedure at least once a month:
1. Make sure laundry drum is empty.
2. Using recommended AFFRESH® washer cleaner, add
one tablet to washer basket.
OR
If using liquid chlorine bleach, add 2/3 cup (160 mL) to
liquid chlorine bleach dispenser.
IMPORTANT: Do not add detergent to CLEAN WASHER
with Affresh™ cycle. Do not use more than recommended
amount of bleach to avoid damaging product over time.
3. Close washer door and dispenser drawer.
4. Press POWER.
5. Select CLEAN WASHER with Affresh™ cycle.
6. Press and hold START/PAUSE.
NOTE: The basket will rotate, then the door will unlock,
lock again, and then the cycle will continue. The washer will
not ll, and the basket will rotate while the washer runs a
short sensing cycle. This will take approximately 3 minutes.
7. The cycle will determine whether clothing or other items
are in the washer. If no items are detected in the washer,
it will proceed to Step 8.
If the Wash LED light ashes, the door will unlock.
Remove clothing or items in the washer. Press POWER
to cancel the ashing LED light. Then repeat steps 1, 2,
and 6 to start the cycle again.
8. Once the cycle has started, allow it to nish. If START/
PAUSE or POWER is pressed before the cycle is
complete, “Int” (Interrupted) will appear in the display.
It may take up to 10 minutes for the door to unlock.
9. After the cycle has ended, leave the door open slightly,
to allow for better ventilation and drying of washer
interior.
To clean exterior:
1. Use a soft, damp cloth or sponge to wipe up any spills.
2. Use mild soap and water if needed.
IMPORTANT: To avoid damaging washer nish, do not use
abrasive products.
Door seal