4.Remove dirt and lint from the condenser fins and the unit compartment with a brush attachment on a vacuum cleaner.
5.Replace the lower access panel using the four screws.
6.Plug in ice maker or reconnect power.
7.Remove the
NOTE: Make sure the plastic spacer from the right- hand side of the cutter grid bracket stays with the cutter grid.
Cleaningthe Interior
Components
1.Unplug ice maker or disconnect power.
2.Open the storage bin door and remove any ice that is in the bin.
3.Remove the drain cap from the water pan and drain thoroughly. Replace the drain cap.
4.Remove the three screws that hold the cutter grid cover in place.
5.Unplug the wiring harness from the left side of the cutter grid.
1.Cutter Grid Cover
2.Screws
6.Unplug the ice level sensor from the right side of the cutter grid. Pull the ice level sensor down and forward away from the cutter grid.
1.Cutter Grid Harness
2.Screw
3.Cutter Grid
4.Ice Level Sensor Harness
5.Plastic Spacer
6.Screw
8.Remove the two screws that hold the water pan in place. Push down with one hand on the front of the pan while pulling forward on the bottom back side.
9.Wash the interior components (cutter grid, exterior of hoses, and water pan) and the storage bin, door gasket, and ice scoop with mild soap or detergent and warm water. Rinse in clean water. Then clean the same parts with a solution of 1 tablespoon (15 mL) of household bleach in 1 gallon (3.8 L) warm water. Rinse again thoroughly in clean water.
NOTE: Do not remove hoses. Do not wash plastic parts in dishwasher. They cannot withstand temperatures above 145°F (63°C).
10.Replace water pan by pushing back on the bottom with one hand while pushing up and back on the top. Secure the water pan by replacing both screws.
11.Check the following:
■Drain cap from the water pan is in place.
■Hose from water pan is inserted into storage bin drain opening.
12.Slide the cutter grid back into place and secure it by replacing the
13.Plug in ice maker or reconnect power.
14
