5. Now you are ready to connect the copper tubing. Use | REAR VIEW | |||||||||
¹⁄₄" (.635 cm) OD soft copper tubing for the cold water |
|
|
|
|
|
|
|
|
|
|
supply. |
|
|
|
|
|
|
|
|
|
|
■ Measure from the connection at the front of the ice |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
maker to the cold water pipe. Add 3 feet to ensure |
|
|
|
|
|
|
|
|
|
|
that you have the proper length. This is the length of |
|
|
|
|
|
|
|
|
|
|
¹⁄₄" (.635 cm) OD soft copper tubing you need for |
|
|
|
|
|
|
|
|
|
|
the job. Be sure both ends of the copper tubing are |
|
|
|
|
|
|
|
|
|
|
cut square. |
|
|
|
|
|
|
|
|
|
|
■ Slip compression sleeve and compression nut on |
|
|
|
|
|
|
|
|
|
|
copper tubing as shown. Insert end of tubing into |
|
|
|
|
|
|
|
|
|
|
outlet end squarely as far as it will go. Screw |
|
|
|
|
|
|
|
|
|
|
compression nut onto outlet end with adjustable |
|
|
|
|
|
|
|
|
|
|
wrench. Do not overtighten. |
|
|
|
|
|
|
|
|
|
|
1.Cold Water Pipe
2.Pipe Clamp
3.Copper Tubing
4.Compression Nut
5.Compression Sleeve
6.
7.Packing Nut
6.Place the free end of the tubing into a container or sink, and turn on main water supply and flush out tubing until water is clear. Turn off
NOTE: Always drain the water line before making the final connection to the inlet of the water valve to prevent possible water valve malfunction.
7.Remove the two screws in the lower access panel and the two screws in the base grille area of the front panel support. Pull forward to remove the lower access panel.
8.Position the tubing so it can enter one of the two access holes located at the
1.Upper Water Line Access Hole
2.Lower Water Line Access Hole
9.Bend the copper tubing to meet the water valve inlet on the water valve which is located in the front of the ice maker cabinet as shown.
10.Unscrew the water valve inlet cover, and attach the copper tubing with the compression sleeve and nut.
NOTE: To prevent rattling, be sure the copper tubing does not touch the cabinet’s side wall or other parts inside the cabinet.
FRONT VIEW
| " |
| " |
" | " |
|
1.Water Pan Drain
2.Water Valve
11.Turn
12.Replace the lower access panel and screws.
8