Replacing the Thermocouple
1.Remove the manifold assembly as directed previously.
2.Remove the retainer clip from the back of the two piece wire connector and remove the two piece wire connec- tor from the manifold door (Figure 25).
3.Pull the thermocouple from the pilot assembly (Figure 29).
IMPORTANT: Be careful not to bend or alter the position of the pilot assembly components.
4.Push the new thermocouple through the holes in the pi- lot bracket. Insert the thermocouple tube into the holes provided in the pilot assembly until it clicks into place.
5.Position the new thermocouple through the larger opening of the two piece wire connector (Figure 25). Be sure igniter wire is positioned through the small open- ing of the two piece wire connector.
6.See Replacing the Manifold Assembly.
Figure 25 | Thermocouple | Other fittings |
Two Piece Wire |
| not shown |
Connector | Igniter Wire | for clarity |
Assembly |
|
|
Two Piece |
| Retainer Clip |
|
| |
Wire Connector |
|
|
| Pilot T ube | Manifold |
|
| Door |
Figure 26 |
|
|
Thermocouple |
|
|
Assembly |
|
|
External Inspection & Cleaning of the Flame-trap
Although not likely to occur, if debris collects on the flame- trap, use a vacuum, compressed air, or a soft bristle brush to remove it. NOTE: If unable to inspect or clean the flame trap from underneath, follow the “Cleaning the Combustion Chamber and
Figure 27 |
Flashlight |
Mirror |
Mirror |
Cleaning the Combustion Chamber and Flame-trap
1.Follow procedure outlined in “Removing the Manifold Assembly”.
2.Use a vacuum cleaner/shop vac to remove all loose debris in the combustion chamber (Figure 28A). Use compressed air to clear any dust or debris that may have accumulated in the
3.Reassemble following the procedure under “Replacing the Manifold Assembly”.
22
